Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="vk9" data-source="post: 679331" data-attributes="member: 14413">will check around for the muffler in kk..btw.... when to use the following:> O/D on/off> Power switch> gear 2 and 1??this is my first auto car, so not very sure about all these functions.... appreciate for your valuable advice, thanks...</blockquote>

Verification

The Marketplace Latest

original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

For the Big Boys Only!

Big intercooler!
XS POWER from USA..(BRAND NEW)
RM2500.00nego
will send if buyer in PJ.
Piping not included!

Tested 6bar presure!
Full lenght 780.5mm
24" x 12" x 4"
3" inlet 3" outlet

Picture below!!!!

DIY wideband monitoring device

You guys like to diy things?
Look here:
http://www.aces.edu/~gparmer/efi/temp/wb/guide.html#circuit%20board

You can monitor the output using a cheap digital voltmeter.

MOTEC M400 ECU for gen2

Any guides out there how to convert my current standard seimens ems700 ecu to a motec m400 ecu do i use back my current sensors in the engine or i need to replace them any guide to progam it to get the standard...