Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="kruger" data-source="post: 602842" data-attributes="member: 9511">Found this on the net, planning to diy this starter interupter that consist of relay and a few wiring. Need info on you guys, to do it or not to do it, coz my cars don't have any immobilizer mar... Well here is the details that i would like to share with you guys, don't know if this topic was posted before or not...Normally Closed Starter Kill Relay:The basic starter kill relay diagram shown below, breaks continuity of the lead from the ignition switch to the starter motor (or in some cases i.e.; Ford, to another relay), when the alarm is armed and the ignition is turned on. This is the most commonly used application for disabling the starter. (Ref Picture 1)Normally Open Starter Kill:This normally open starter kill relay application below relies on a ground from the alarm when disarmed and 12 volts (+) from the ignition to enable the driver to start the vehicle. * Note: most alarms with this feature will not provide this grounded output when power ,12 volts (+), to the alarm is not present, even if the alarm is grounded. (Ref Picture 2)Passive Starter Kill:This is a stand alone starter kill. It does not rely on an alarm or keyless entry for it to work, only a simple momentary contact switch (normally open) to deactivate it. Every time the ignition is turned off, continuity is broken on the starter feed wire. To disable (or start), turn ignition on, then press the hidden switch, then start as normal. (Ref Picture 3)You can substitute the switch with a number of others devices such as the amp turn on lead of your head unit. Be sure to isolate it with at least a 1 amp diode. Turn the key to the run position. Allow the head unit to come on or turn it on. Now start the vehicle. If you connected to the power antenna lead, make sure the tuner is on. If you have a pullout or detachable face head unit, your vehicle will not start without it. (Ref Picture 4)If you wish to use a device such as your horn, but do not want the horn to sound when you deactivate the starter kill, yet still work when driving, you can use the same configuration above on both the horn and the starter lead as shown below. The starter kill is deactivated by the positive output of the vehicle's horn relay and the horn's interrupt is deactivated by the positive output of the starter lead from the key. You could substitute the horn with other devices such as parking lights, brake lights, etc. where you do not want it to be obvious that you used the device to disable the starter kill. (Ref Picture 5)So guys, better make witch one ha???? :D</blockquote>

Verification

The Marketplace Latest

original rare Yokohama ADVAN Racing TC4 18x8.5...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing ZE40 17x9jj offset...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing INGS TS06 18x8jj...
- Started by david tao
- Chassis and Wheels
New original Defi Advance A1 NA package triple...
- Started by david tao
- Engine and Performance
original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Toyota altezza is200 1999 for sale!

Toyota altezza rs200 1999 for sale!

TOYOTA ALTEZZA RS200
[*] light orange
[*] year 1999
[*] Auto 5 speed Tiptronic
[*] Beams Engine "Black top" Yamaha tuned 3S-GE inline-4 engine...

Anyone can guide me to re-spray myvi rear bumper?

Anyone can guide me to re-spray myvi rear bumper?

I got a big scratch on my rear bumper , can someone guide me to re-spray the whole bumper? Or can i just spray the scratch part only?

The main problem for me is i...

RE rebuilds - the inside story!

Have you ever wondered what your rotary engine looks like inside?

Here are some photos of the rebuilds we have completed to date. You'll notice that it is very important that all component parts are cleaned to a...