Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="12savefuel" data-source="post: 1063598430" data-attributes="member: 69762">You need to check your base idle speed. If the base idle speed is too low when the speed is correct (about 55km/h i think) and you are in 3rd gear and you lift off 100% and let the car roll, and the trans changes to 4th gear the rpm will drop to close to 500rpm. If your base idle speed is not set at 600-700 rpm the engine will stall. That is presuming that there is no other mechanical problems with the car like vacuum leak etc.Based idle speed is set with the electronic idle control valve disconnected. Base idle speed means idle speed of the engine with no load all accessories off and no compensation by the EACV. So e.g. if you set the base idle at 400rpm then you connect back the EACV the EACV will compensate back to the preset value of 650rpm. So therefore the based idle speed is wrong.</blockquote>

Verification

The Marketplace Latest

Mitsubishi lancer Evo x front bumper
- Started by jeff6126
- Exterior and Body
Honda jazz fit gk flrs body kit
- Started by jeff6126
- Exterior and Body
Proton S70 body kit
- Started by jeff6126
- Exterior and Body
Proton saga BLM body kit
- Started by jeff6126
- Exterior and Body
Perodua bezza ~accident repair
- Started by jeff6126
- Exterior and Body
Mercedes Benz W205 C-class GT grille
- Started by jeff6126
- Exterior and Body
BMW E90 ~brake caliper spray ~rim spray
- Started by jeff6126
- Exterior and Body
Honda city gm6 FL front bumper
- Started by jeff6126
- Exterior and Body
original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels

Posts refresh every 5 minutes

Rpm drop when gas pedal been tap..

Guys.. i had one blady prob... :biggrin:

When i tab my gas pedal suddenly, my rpm will drop first and then it climb normally ..

At neutral when i tab my gas pedal the boost meter climb to 0. bar but the RPM drop...

[ask] Rolling fender

Bro zth-ers... i wanna ask bout rolling fender... do anyone know the best place to roll fender? if can, easy budget also.. thx

rgrds,

Gauze

Soundproof

Guys, I've been with ZTH for sometime. But, this is the first time posting. Hopefully you guys might help.

Well, has anyone been soundproof Iswara Aeroback before? Espeacilly the trunk. As what I noticed, there are...