Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="DJmobile" data-source="post: 660764" data-attributes="member: 1192">you can do it alone, they will give you a number upon entrance.. ( for my case)the engine is to be endorsed, modification you did as long as within the specs and not tamper with the car chassis then ok liao...If your car is lowered, make sure you can CLEAR a coke can standing upwards, note, there will ne a concrete slab at puspakom that is the height of a coke can, if you can clear the coke can means ok, will not kena bumper and stuffs...Engine code and chassis number is something they will check of course...No hanky tinting of windows remember...lastly bring around 50 bucks for the inspection....</blockquote>

Verification

The Marketplace Latest

original rare Rays Volk Racing TE37SL Black Edition...
- Started by david tao
- Chassis and Wheels
Honda city JSracing gtwing spoiler
- Started by jeff6126
- Exterior and Body
Honda civic fd ~car spray(Ferrari red)
- Started by jeff6126
- Exterior and Body
Honda jazz fit gk flrs body kit
- Started by jeff6126
- Exterior and Body
BMW F10 ~M5 front skirt lip with glossy black
- Started by jeff6126
- Exterior and Body
Kia Forte gtwing spoiler
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body
Proton Saga VVT Evo Front Bonnet Hood
- Started by jeff6126
- Exterior and Body
Perodua bezza gear up body kit/spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 ~M5 front bumper set ~M5 kidney grille...
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Seeking advice on jerking problem (Lancer Sportback 2.4)

Hello friends, im a newbie here. my lancer sportback recently got jerking problem after routine service done at glenmarie mitsubishi service (change engine oil & spark plug @100k millage). First time i noticed the...

Using spacer

Hello everyone

Care to review the pros and cons using spacers?

DIY Gauge Holder / Pod

This are my DIY gauge holders....:regular_smile: Very amateur..heheh
Comments are welcomed...

Material used:

1 x Plastic Clipboard (forgot how much)
2 x 2" PVC Hose Elbow (RM2 each)
1 x Spray Paint (RM5)
1 x Anti...