Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="evan2000" data-source="post: 1793554" data-attributes="member: 38">true, thats why if the tyre shop only inflate ur tyre with nitrogen then it wont be 100%. Should doing purging, fill in and release, and refill it again. Try to minimise the other gases.Well, about the rusted of steel belt case and bengkak most of the time it happen on those commecial vehicle, which the amount of air, pressure are much higher.Ofcoz, i will say nowadays if the air compressor installed with drier( most compressor nowadays got it with filter too) and service well, the moist in the air are very minumum. By using the nitrogen it just further minimize the possibility.I do understand that the cost of refilling nitrogen is relatively high. And it may not that significant in the pay back. I would say, nitrogen is better option than normal air inflation, however when $$$$ issue comes in, its different story.Lastly, i do see that nowadays quite alot tyre shop offer free refill if u purchase tyre from them.Actually doncityZ, what you doing is really good enough in tyre maintainance.Keep it up dude!</blockquote>

Verification

The Marketplace Latest

New original Defi Advance A1 NA package triple...
- Started by david tao
- Engine and Performance
original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body
Mitsubishi Lancer Evo bodykit
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Spied: 2012 Mitsubishi Mirage in Subang - Soon to be sold in Malaysia?

http://www.zerotohundred.com/../wp-content/uploads/2012/04/mitsubishi-mirage-in-malaysia-3-600x450.jpg

As you can see from the heavily shrouded example of what looks to be the latest Mitsubishi Mirage, currently...

Engine Cover Spray , Lettering emblem only

What u need

1 . your spray paint
2. masking tape
3. fire source
4. candle
5. hair dryer

Ok first melt candle on ur engine head where needed like this ...

Heat resistant spray

Guys,

Looking for heat resistant spray, want to try a little DIY project as I've never
tried it before .. haha .. I want it in RED, tried looking in ACE hardware,
both Mid V and Ikano but to no avail, any ideas...