Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="-storm-" data-source="post: 2192471" data-attributes="member: 37224">:retarded: Mayb only works on higher speed!Here is the explaination for this device :Turbulators, etc:In areas where the body transitions at a rate of more than 12 degrees, turbulator strips, vortex generators, diffusers, very short fairings or other devices can be used to "trip the airflow". The idea is that areas like the transition between the roof and rear window on the average car creates a large vortex. Any large vortices effectively grab the car and try to hold it back as it tries to slip through the air. If the air that makes up the vortex can be "tripped" before it leaves the back of the car, it will make smaller vortices, which will have a smaller effect on the overall aerodynamics of the vehicle. Measurement of the effects of these devices at highway speeds has been difficult to obtain.Quoted from: <a href="http://www.recumbents.com/car_aerodynamics/" target="_blank">Car Aerodynamics 101</a></blockquote>

Verification

The Marketplace Latest

Mitsubishi lancer Evo x front bumper
- Started by jeff6126
- Exterior and Body
Honda jazz fit gk flrs body kit
- Started by jeff6126
- Exterior and Body
Proton S70 body kit
- Started by jeff6126
- Exterior and Body
Proton saga BLM body kit
- Started by jeff6126
- Exterior and Body
Perodua bezza ~accident repair
- Started by jeff6126
- Exterior and Body
Mercedes Benz W205 C-class GT grille
- Started by jeff6126
- Exterior and Body
BMW E90 ~brake caliper spray ~rim spray
- Started by jeff6126
- Exterior and Body
Honda city gm6 FL front bumper
- Started by jeff6126
- Exterior and Body
original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels

Posts refresh every 5 minutes

Detuned

Guys,

can i actually detune a high performance car to a daily drive-able car?

for example, a heavyly modified skyline with over 500 hp... would it be possible that i detune it to about 300hp so that it's more fuel...

1jz gte exhaust setup

wad is the ideal exhaust setup for a stock or slightly modified 1jz-gte auto engine?
A) 3 inch piping all the way wif straight flow bullet n straight flow muffler
B) 2.5 inch piping all the way wif straight flow...

Thanks To All DIY Forumers...

Here some of the DIY things that i've learn from this marvelous ZTH Forums:D.
Click on the DIY section.

Click here:
http://kruger.fotopic.net