Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="aircooled" data-source="post: 1243601" data-attributes="member: 3840">encik masen, theoretically, yes, you can do it. but in real life please dont do it.when ayou are building a high performance engine which should pump out 150bhp around there depending on the other components and head work, you need a strong base. best is to start with a BRAND NEW CASE. however, in malaysia, this is not really possible due to cost. Your best option is to buy a 1600 cc dual port engine case , the late model case with 8mm head studs. and start from there. Bear in mind the case must not have been machined before on the bearing saddles which means never overhauled before and still uses the STD STD bearings.boring to 94mm will bring you to only 1914cc with stock stroke. this uses a different piston with deper piston pin, usually known as piston type A.to get 2332cc, you need piston type B, still 94mm. you need a crankshaft like the one i have for sale. Must be high quality forged. then u need longer con rods. Cb H beam is a good choice. then u need longer head studs, preferably chromoly.there are many more stuff to go with it to make HP. to do all these requires a lot of agung and it is not really feasible in Malaysia. you can spend 1/5 of the amount to get 200bhp in a Japanese car.</blockquote>

Verification

The Marketplace Latest

New original Defi Advance A1 NA package triple...
- Started by david tao
- Engine and Performance
original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body
Mitsubishi Lancer Evo bodykit
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

wts FC bride racing seat rail

driver site
Rm220

Diy N2o.

Anybody wants to try diy N2O.....???

Survey: Mileage achieved for RM50 petrol

dudes...if u wud b so kind...pls state down:

1. car type
2. engine type
3. mods done to engine
4. ??km for RM50 petrol
5. etc other stuff which might be related...

cheers...