Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="^pomen_GTR^" data-source="post: 1064667437" data-attributes="member: 92301">car will be out of cold start procedure and thermostat opening allowing water to flow into engine after 85degree C...the radiator fan will run after 100degree Cso sport thermostat usually have 75degree C openingi would say anything between 75degree C up to 100degree C is normal... unless when u were stopping and radiator fan running but still see temperature above 100degree Cor while moving at highway speed with water temp steadily over 100degree C.... usually while moving at steady speed, water temp will remain below 95degree C....and usually above 85degree C (depend on thermostat setting)</blockquote>

Verification

The Marketplace Latest

original rare Rays Volk Racing ZE40 17x9jj offset...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing INGS TS06 18x8jj...
- Started by david tao
- Chassis and Wheels
New original Defi Advance A1 NA package triple...
- Started by david tao
- Engine and Performance
original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

661hp Hamann Tycoon Evo M based on BMW X6M

https://www.zerotohundred.com/wp-content/uploads/2010/02/Hamann-TYCOON-EVO-M-based-on-BMW-X6-M-18-600x398.jpg

Hamann will be showing off it's latest creation at the 2010 Geneva Auto Show - the Tycoon Evo M...

NY Roadtrip anyone?

As per title.... anyone? :driver:

subwoofer material

Hi All,

anybody know where to get 1" pre-cut MDF board for subwoofer in PENANG? I have been searching everywhere. want to make my own sub. could only find 3/4" one in hardware store.

not cut also can.

thanks.