Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="B18C-R" data-source="post: 3809617" data-attributes="member: 78534">james, I have used 2 sets of both HKS Hyper-D and HKS Hypermax before. Frankly, they are good but very noisy (due to their pillowball mount) but they are definately good if you can bear the noise. I've also used Ohlins and is too hard IMO for streets. Perhaps is the series.So far one of the best I tried was CSL Japan (all rounder), and also Tein Type-Flex (all rounder yet very quiet). Now I am back to stock suspension and it sucks..zzz.I drive a lot of estate hill road and winding trunk road (Tampin-Gemas-Segamat) during weekend as my in-laws are in small town out of KL hence my defination of good is for that purposes and not really track. Hope I helped to answer your question.Others discussed by the rest I can't comment as I have no experience using them.Hope this helps a bit to your questions.</blockquote>

Verification

The Marketplace Latest

original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body
Mitsubishi Lancer Evo bodykit
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

[WTA] Labor cost

Hey guys, wanna ask what is the labor charges for rim swapping / tyre swapping? (e.g: swapping a set of rims with my existing rims / swapping a set of tyres with my existing tyres)

hope some of u guys can enlighten...

big question

does our JDM model have pre-cat like the USA models ?

i'm not sure mine still inside. but i know mine doesn't have a 3 inch downpipe :)

Oil Cooler for ER34

Hi all,

Are you running any oil coolers for your ER34? If not what are the normal oil temp you are getting? I'm getting circa 110 degrees on prolonged high speed runs (circa 180km/h) and it's worrysome.

For...