Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="synchron" data-source="post: 1052852" data-attributes="member: 115">Yes! forged parts are also breakable.When the forged con-rod breaks, they are different from casted parts.I m still waitting for my friends 3sgte Tom's forged con-rod to come back. He broke them with 2.6 bar. By then i can tell if the Toyota con-rod are forged or not.I can tell that the Toyota pistons are not forged. Basically forged pistons are very strong material and they have very thick walls than the cast pistons have. The few basic chracteristic of a forged pistons is when you start the engine when it is cold, you will get alot of white smoke. It is because the expenditure rate of the forged pistons are very high and they also need alot of clearance on the cylinder for the forged pistons to expand when it is hot.The second characteristic is when the engine is in high RPM or high boost, running very lean. The forged pistons will just melt away like a alluminium rather than cast pistons where they break into pieces.That is all I can say for stock Toyota pistons.</blockquote>

Verification

The Marketplace Latest

original rare Rays Volk Racing CE28 16x7jj offset...
- Started by david tao
- Chassis and Wheels
Honda Jazz/Fit JSracing GTwing Spoiler
- Started by jeff6126
- Exterior and Body
Toyota Vios NCP93 front bonnet hood
- Started by jeff6126
- Exterior and Body
Honda civic fc varis spoiler
- Started by jeff6126
- Exterior and Body
BMW F10 Msport front bumper set
- Started by jeff6126
- Exterior and Body
BMW F30 M3/GTS front bonnet hood
- Started by jeff6126
- Exterior and Body
BMW F10 vorsteiner rear bumper diffuser
- Started by jeff6126
- Exterior and Body
Mitsubishi Lancer Evo bodykit
- Started by jeff6126
- Exterior and Body
BMW F30 M3 front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

everything about adj suspension

ok i had try the tein super street not satisfied for going fast. not recommanded. Now i am using hks hipermax 2 is good but not hard enough for me.

i wanna ask, can i change spring rate?? using the same brand...

4 Yrs in the Making of Pink xxx ... The dream is finally coming true!

Hello guys an gals.

This is the long story takes place 4 yrs ago, when i aquired a No Cash T3/T4 turbo setup from Gene Hypertechnokraft, an once dropped it in my faded pink 92 turbo mr2. Once i started her up i...

Air Fuel Setting, How To Setting

Hello dude,

Can anyone tell me how to setting the air fuel setting?
Someone told me is by adjust the MAS screw at the Throttle Body, a screw with spring.

Can anyone show me where is the screw?
I'm using an satria...