What's For Rear Speakers?

[oldskolboyz]

Frend no sub no meaning lorr.... like eat pisang goreng without Kopi O'l... haaa haaa

 

[Tohsan]

oldskolboyz

ya! like have sex with condom on, no syok man muahahahahahahaha

 

[Zenn]

weh aku makan pisang goreng dgn teh-o ok jeee peeeeee........

instead of buying 2 sets of cheap component speakers, why dont u buy just one good comp set for the front, leave the rear stock or some other old set. use the amp 4ch bridged into 2 to run the front components, use the HU power for the rear. later on when u get the sub just connect back to the 4ch amp all kautim oledi...

 

[Tohsan]

Zenn

cukupka use 4 channel for component and sub?

 

[Zenn]

cukup laaaaaa...2ch for front and 2ch bridged for sub.....got ppl win competition also like this.....hehe

 

[oldskolboyz]

weh aku makan pisang goreng dgn teh-o ok jeee peeeeee........

Biasa laa.... Oldtimer mesti kena Kopi O' kaw barulah masuuuuuuukkkkkkk.. haa haa

 

[acidcoller]

bro

suggest u component for front, 2 way for rear and 12" for sub

 

[ahmisuhairi]

They said that overpowering the speakers is good. How much over-powering that it suitable?

 

[Zenn]

good speakers can stand up to double their rms bcoz u dont play at full volume, just make sure the amp gain is not set too high...

 

[ahmisuhairi]

currently using GTi608 for front door, coax on rear deck. both powered by px300.4

My next step change rear to component too and 1 sub and monoblock...

 

[Pjam]

currently using GTi608 for front door, coax on rear deck. both powered by px300.4

My next step change rear to component too and 1 sub and monoblock...

suggest the $$ spend on rear to be spent on good/better sub & monoblock
no point changing rear coaxial to component set unless u have strong reason to do so

 

[ahmisuhairi]

thank bro... for ur advice. So can I 2ch with the amp for the front speaker and install good sub with mono for rear...

COMPONENT SPECIFICATIONS
Power Handling, RMS 150 Watts
Power Handling, Peak 600 Watts
Frequency Response (±3dB) 50Hz - 21kHz
Sensitivity (2.83V @ 1m) 89dB
Impedance 4 Ohms
Crossover Frequency(ies) 3.5kHz, 24dB/oct

AMP SPECIFICATIONS
Power Output 123.5 watts RMS x 4 channels at 4 ohms and ≤ 1% THD + N
358 watts RMS x 2 channels at 4 ohms, 14.4V supply and ≤ 1% THD + N
Signal-to-Noise Ratio 76.64 dBA (reference 1 watt into 4 ohms)
Dynamic Power 194 watts at 4 ohms
Effective Damping Factor 6.383 at 4 ohms
Frequency Response 16.6Hz – 500kHz (-3dB)
Maximum Input Signal 5.9 V
Maximum Sensitivity 250 mV
Output Regulation .39 dB at 4 ohms

with the spec above can I run 358 watts RMS x 2 channels?

 

[Zenn]

sell the rear 6x9 coaxial to a friend and use that money + top up for a sub, can retain the current 4ch amp and bridge ch 3&4 to run the sub, all kaw tim...

 

[oldskolboyz]

thank bro... for ur advice. So can I 2ch with the amp for the front speaker and install good sub with mono for rear...

I think Ur 9833 built-in crossover can ran full active 3ways.. mean Front (HP)- tweeter, Rear (BandPass) - midbass & Sub woofer (LP)...

If U have budget for Sub + amp (either 2ch or mono).. it quite good also.. Ur ICE can improve more & at the same time U can fully utilize your 4ch amp.. front(1/2) drive tweet & rear(3/4) drive midbass.. if dont have budget at this moment just follow what zenn said (basic set-up).. 1/2 front comp & 3/4 briged drive sub...

 

[Pjam]

choices.. choices
1. as what zenn suggested

2. as what oldskolboyz suggested, fully utilise 4-channel amp, active setup; get monoblock for sub

3. maintain passive x-over; 4-channel amp: 2-channel to power components, 2-channel to power rear (attenuated); monoblock to power sub

all depends on budget
by the way, what sub, monoblock u have in mind?

 

[ahmisuhairi]

THANKS FOR THE SOLUTIONS...

BTW WHATS THE MEANING ACTIVE SETUP? I PLAN TO GET MONO AMP AND SUB AFTER THIS AND WILL TAKE OUT THE 6X9 SPEAKERS, SO FOR THE COMPONENT ON MY DOOR PANEL SHOULD I LEAVE IT LIKE AS IT IS OR SETUP IT 358 watts RMS x 2 channels at 4 ohms?

 

[ahmisuhairi]

My Friend Is Selling His Sstream T4-10 800w Dvc. Good Deal Or Not? Is It Possible To Find 1000w Rms Amp For It? Affraid The Bass From Sub Too Loud And Will Reduce The Front Speaker Staging.

 

[acidcoller]

bro..
recommended u use FOCAL

 

[Zenn]

dont worry about the sub u can control from your HU...

 

[vladimir]

currently im using :-

1 set pentagon 6' mid ( front )

1 set focal polyglass 6' mid ( rear )

1 set kicker solo baric L7 ( boot )

so far ... feel not enuf ohmm due to no preamp...hehehhe going to get a preamp soon :_:

u should grab some branded speaker for rear inorder go get ur room filled the sensation ma~ if u only have the front speaker u will feel something missing..

the sound airflow disturbed.

u can get alot branded component from me cheap~ click my link lo~!