Can't pass by 5k RPM

[mh wong]

possible

 

[vr2turbo]

Maybe your clutch slip at high rpm?

If clutch slip, then his RPM will go higher, but speed slower.....

---------- Post added at 08:52 AM ---------- 6 hour anti-bump limit - Previous post was at 08:48 AM ----------

i think i should check the air con gas pressure as i just serviced the air cond last week .
throttle body i just serviced few months back. anyway i will get this two things checked.

Can just off the air con and try again, and more over you should off the air con compressor when doing high rev. Firstly you will get more power, and secondly you will save the compressor on the long run. Air con compressor running on high rpm may not last long....

 

[Neo_]

If clutch slip, then his RPM will go higher, but speed slower.....

so i guess its definelty not clutch slip

---------- Post added at 08:52 AM ---------- 6 hour anti-bump limit - Previous post was at 08:48 AM ----------


Can just off the air con and try again, and more over you should off the air con compressor when doing high rev. Firstly you will get more power, and secondly you will save the compressor on the long run. Air con compressor running on high rpm may not last long....

tried with air cond off , same only .
and i realised this problem is not consistent , kinda on and off.sometimes ok
sometimes cannot go .. :hmmmm:

 

[mh wong]

 

[vr2turbo]

tried with air cond off , same only .
and i realised this problem is not consistent , kinda on and off.sometimes ok
sometimes cannot go .. :hmmmm:

Oh! like that need mechanic to check throughout......

 

[Neo_]

y not check wif this pomen, Ah Fatt 016-292 0668, Damai Perdana

is he familiar with campro bro ?

yes,i shud go and check it out soon

 

[ronaldindin]

any update regarding your issue? Would like to know the problem too

 

[Neo_]

any update regarding your issue? Would like to know the problem too

so far no bro,kinda busy with work so haven't bring to workshop yet ..
last night i tested again ,cold weather , engine was warmed up .
can go untill 6.5 k .. i suspect something is wrong with my piping system .
will update here once i get it checked.

 

[Danial Leroux]

if you have check almost everything,try referring to its original source.RPM is when the crankshaft rotates.check the crankshaft

 

[vr2turbo]

if you have check almost everything,try referring to its original source.RPM is when the crankshaft rotates.check the crankshaft

Interesting, what will be wrong with the crankshaft?

 

[Danial Leroux]

Interesting, what will be wrong with the crankshaft?

maybe theres a crack or it is crooked in some way.but then again,we never know because shit happens